|
|
 |
|
|
|
|
 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
 |
|
|
|
|
|
|
|
|
| PAVE EDGE for Concrete or Asphalt Overlays: |
|
| PAVE EDGE for Concrete or Asphalt Overlays |
|
The recent popularity of rehabilitating old pavements by overlaying interlocking paving stones has opened more options to the Architect/Engineer. PAVE EDGE is the perfect product for such installations.
PAVE EDGE Rigid or Flexible can be used when installing pavers over an existing concrete or asphalt surface. If the existing surface has cracks, first cover the pavement with a filter fabric to prevent bedding sand loss. The fabric should extend an inch or two beyond the outside of the edging. On projects that do not require filter fabric over the entire surface, a 3' wide strip of filter fabric should be laid before the edging, sand and pavers are installed. This fabric should also extend 1" - 2" beyond the PAVE EDGE. This will help moisture in the bedding sand to wick out. To anchor PAVE EDGE to the concrete or asphalt, use 2" long x 1/4" diameter hammer-set concrete anchors and 1/4" fender washers. For straight runs, snap a chalk line and then place the edging on top of the fabric. Either using the pre-drilled holes in the edging or going through the back support, use a hammer drill with a 1/4" concrete bit. Drill 2" into the concrete or asphalt to ensure the anchor will go all the way down to the top of the edging. Space the anchors the same distance as when using spikes in a typical installation. Alternatively, PAVE EDGE can also be anchored through the lip instead of the back support.
|
|
|
|
|
|
|
|
|
|
|
 |
|
|
|
|
|
|
|
|
|
|
|
